Vlan-Tunnel Ctag-Mapping Static - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vlan-tunnel ctag-mapping static

vlan-tunnel ctag-mapping static {A.B.C.D/M | X:X::X:X/M} C-VID
no vlan-tunnel ctag-mapping static {A.B.C.D/M | X:X::X:X/M}
Syntax Description
A.B.C.D/M
X:X::X:X/M
C-VID
Default
Command Mode
Usage Guideline
Examples
Switch(config)# vlan-tunnel ctag-mapping static 10.90.90.1/24 500
CLI Reference Guide
Use this command to add a static customer VLAN tag mapping entry. Use the no
form of the command to delete a static customer VLAN tag mapping entry.
Specifies the destination IPv4 network address.
A.B.C.D: IPv4 address
M: IPv4 prefix length, maximum length is 32.
Specifies the destination IPv6 network address.
X:X::X:X: IPv6 address
M: IPv6 prefix length, maximum length is 128.
The VLAN ID specified here refers to the inner-VID (i.e. customer VLA ID)
Not configured
Global configuration
Use this command to add a static customer VLAN tag mapping entry for the
specified IP subnet.
This example shows how to add a static customer VLAN tag mapping entry.
Using the following configuration, the C-VID 500 is used to add the out-going
control packet which has destination IP equal to 10.90.90.1/24 subnet.
Verify the settings by entering show vlan-tunnel ctag-mapping static
command.
vlan-tunnel ctag-mapping static
906