Set Ip Precedence - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

set ip precedence

set ip precedence {NUMBER | NAME}
no set ip precedence {NUMBER | NAME}
Syntax Description
NUMBER | NAME
Default
Command Mode
Usage Guideline
Example
Switch(config)#route-map example permit 10
Switch(config-route-map)# match ip address IPACL_01
Switch(config-route-map)# set ip precedence 5
Switch(config-route-map)# exit
Switch(config)#interface vlan100
Switch(config-if)#ip policy route-map example
Switch(config-if)#exit
Switch(config)#
CLI Reference Guide
Use the set ip precedence command in route-map configuration mode to set the
precedence value in the IP header. Use the no form of the command to remove
the setting.
Specify one of the following numbers or names to set the precedence value in
the IP header:
Number
0
1
2
3
4
5
6
7
Not configured
Route-map configuration
Use the command to set the precedence value in the IP header.
The precedence can be set using either a number or the corresponding name.
The following example sets the IP Precedence value to 5 (critical) for packets
that pass the route map match.
You can verify your settings by entering the show route-map privileged EXEC
command.
Name
routine
priority
immediate
flash
flash-override
critical
internet
network
set ip precedence
540