Ip Ospf Authentication - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip ospf authentication

ip ospf authentication [ message-digest ]
no ip ospf authentication
Syntax Description
message-digest
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip ospf message-digest-key 10 md5 yourpass
Switch(config-if)# ip ospf authentication message-digest
CLI Reference Guide
Use this command to send and receive OSPF packets with the specified
authentication method. Use the no form of this command to disable the
authentication.
(Optional) Use the message digest authentication.
No authentication
Interface configuration
The authentication mode can be: no-authentication, use authentication key for
authentication, or use message-digest key for authentication.
When it is specified to use the authentication key but the key is not configured,
then null key will be used.
When it is specified to use the message digest but the digest key is not
configured, then the null key will be used.
In the following example shows how to enable message authentication on
interface VLAN 1.
Verify the settings by entering the show ip ospf interface command.
ip ospf authentication
276