Arp Timeout - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

arp timeout

arp timeout SECONDS
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface vlan1
Switch(config-if)# arp timeout 12000
CLI Reference Guide
Use the arp timeout command to set the ARP aging time for the ARP table.
Number of seconds that dynamic entries will remain in the ARP table before
being deleted; valid values are from 0 to 65535.
14400 seconds (4 hours)
VLAN interface configuration
Only VLAN interfaces are valid for this command.
This example shows how to set the ARP timeout to 12000 seconds to allow
entries to time out faster than the default setting:
Verify the settings by using show ip interface command
arp timeout
54