Dot1X Auth-Protocol - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

dot1x auth-protocol

dot1x auth-protocol {local | radius}
Syntax Description
local
radius
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# dot1x auth-protocol radius
CLI Reference Guide
Use this command to specify the authentication method used for 802.1x
authentication.
Specifies local accounts for authentication
Specifies RADIUS servers for authentication
radius
Global configuration
If local is specified, a user account should be configured. Please refer to the
dot1x user command on page 175 to create new user accounts.
If radius is specified, a RADIUS server should be configured for authentication.
Please refer to the server command on page 526 in "AAA Feature
Commands" on page 1.
The following example shows how to specify the authentication method as
RADIUS.
Verify the settings by entering the show dot1x command on page 577.
dot1x auth-protocol
161