Netbios Node-Type - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

netbios node-type

netbios node-type NTYPE
no netbios node-type
Syntax Description
NTYPE
Default
Command Mode
Usage Guideline
Example
switch# configure terminal
switch(config)# ip dhcp pool pool1
switch(config-dhcp)# netbios node-type h-node
CLI Reference Guide
This command is used to configure the NetBIOS node's type for Microsoft
Dynamic Host Configuration Protocol (DHCP) clients. Use the no form of this
command to restore the configuration of the NetBIOS node's type back to default
configuration (Hybrid).
Specifies the type of NetBIOS node. Valid types are listed below:
• b-node - Broadcast
• p-node - Peer-to-peer
• m-node - Mixed
• h-node - Hybrid (recommended)
NTYPE: h-node
DHCP pool configuration
This command configures the NetBIOS node's type; the recommended type is h-
node (Hybrid). It determines what methods NetBios will use to register and
resolve names.
• b-node - The broadcast system uses broadcasts.
• p-node - A p-node system uses only point-to-point name queries to a
name server (WINS).
• m-node - An m-node system broadcasts first, and then queries the name
server.
• Hybrid - A hybrid system queries the name server first, and then broad-
casts.
Resolution through LMHOSTS and/or Domain Name Service (DNS), if enabled,
will follow these methods.
The following is sample of configuring the Netbios node type as h-node.
netbios node-type
441