Tunnel Source - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

tunnel source

tunnel source { IPv4-ADDRESS }
no tunnel source
Syntax Description
IPv4-ADDRESS
Default
Command Mode
Usage Guideline
Examples
Switch(config)# interface tunne 2
Switch(config-if)#tunnel source 10.0.0.1
Switch(config-if)#
Switch(config)# interface tunne 2
Switch(config-if)#no tunnel source
Switch(config-if)#
CLI Reference Guide
Use the tunnel source configuration command to add the source IPv4 address
for the tunnel interface. Use the no tunnel source configuration command to
remove it.
IPv4 address.
None
Interface configuration
Use this command to configure the source IPv4 address for a tunnel interface.
Tunnel interfaces are valid for this command.
This example shows how to add the source IPv4 address for the tunnel interface
2
This example shows how to remove the source IPv4 address for the tunnel
interface 2
Verify the settings by entering the show interface command.
tunnel source
895