D-Link DGS-6600-48T Cli Reference Manual page 886

DGS-6604 m
Switch#telnet 20.74.19.200
Connecting to 20.74.19.200 ...
Connected to 20.74.19.200.
Escape character is 'Ctrl-_'.
Telnet connecting ...
Copyright (c) 2010 D-Link Corporation. All rights reserved.
Switch>
Supported commands are:
e -
If other key is pressed, the terminal will return to the original active
Telnet session.
continuing...
Switch>
CLI Reference Guide
The following example show how to telnet to the IP address 20.74.19.200 with
default port 23, then enter the escape sequence : Ctrl-_ and press any other key
returning to the telnet session.
Chassis-based High-Speed Switch
Command Line Interface
Firmware: 1.00.0029
terminate the current Telnet session
telnet
876