Vrrp Shutdown - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vrrp shutdown

vrrp VRID shutdown
no vrrp VRID shutdown
Syntax Description
VRID
Default
Command Mode
Usage Guideline
Examples
Switch(config)#interface vlan1
Switch(config-if)#vrrp 7 ip 20.1.1.1
Switch(config-if)#vrrp 7 shutdown
Switch(config-if)#
Switch(config-if)#vrrp 8 ip 20.1.1.2
Switch(config-if)#
Switch(config)#interface vlan1
Switch(config-if)#no vrrp 7 shutdown
CLI Reference Guide
This command is to disable the VRRP of a VRID on an interface. Use the no form
of the command to re-activate the VRRP.
Specifies the virtual router identifier, the number identifying the virtual router that
the shutdown is being configured for.
The virtual router identifier is configured with the command "vrrp ip" on
page 917.
Range is from 1 to 255.
None
Interface configuration
When a VRRP VRID is being configured using the vrrp VRID ip command, the
protocol will be fully operational. Using vrrp shutdown disables the protocol
operation for one VRID of an interface.
The following example shows how to disable one VRRP VRID 7 on interface
vlan1 while retaining the VRRP VRID 8.
The following example shows how to re-activate VRRP protocol on VRID 7 of
interface vlan1.
vrrp shutdown
922