Show Loopback-Detection - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show loopback-detection

show loopback-detection [interface [INTERFACE-ID] [, | -]
Syntax
<cr>
Interface
INTERFACE-ID
,
-
detail
Default
Command Mode
Usage Guideline
Example
Switch# show loopback-detection
Status
Mode
Interval
Interface LoopDetect State
------------- --------------------- ----------------- --------------
eth3.1 Enabled
eth3.8 Enabled
eth4.5 Enabled
CLI Reference Guide
Use the command to show the current loopback detection control settings.
To show all the loopback detection protocol information.
Specify the interface-ID which you want to display.
(Optional) Specify a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specify a range of interfaces. No space before and after the hyphen.
(Optional) Displays detailed information about the spanning-tree state.
None
EXEC mode or any configuration mode
Show the loopback detection information.
This example shows current loopback detection setting and running status for
port-based mode.
: Enabled
: Port-Based
: 20 s
Result
Normal
Normal
Loop
show loopback-detection
Time Left(sec)
20
705