Ip Pim Register-Checksum-Include-Data - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip pim register-checksum-include-data

ip pim register-checksum-include-data { group-list ACCESS-LIST-NAME}
no ip pim register-checksum-include-data
Syntax Description
group-list
ACCESS-LIST-NAME
Default
Command Mode
Usage Guideline
Example
Switch(config)# ip pim register-checksum-include-data
CLI Reference Guide
Use this command to configure the option to calculate the Register checksum
over the whole packet. Use the no form of this command to disable calculating
the Register checksum over the whole packet.
Specifies the name of the basic IP access list name
Disabled
By default, the Register Checksum is calculated only over the header.
Global configuration
This command is valid for SM mode and used to provide compatible inter-
operability with other manufacturer devices per the following:
This command is used to inter-operate with some legacy CISCO® manufactured
routers using older CISCO® IOS™ versions. This command is needed for the
first hop router for encapsulation of the register packet. This function needs to be
enabled in order to inter-operate with legacy CISCO® devices using older IOS™
versions.
If group-list is not specified, then the setting will be applied to all groups.
This command can be only specified once. The later applied command will
override the previous setting.
The following example shows how to enable register checksum over whole
packet.
Verify the settings by using the show ip pim command.
ip pim register-checksum-include-data
295