Neighbor Send-Community - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

neighbor send-community

neighbor { IP-ADDRESS | PEER-GROUP-NAME } send-community [both | standard |
extended]
no neighbor { IP-ADDRESS | PEER-GROUP-NAME } send-community [both | standard |
extended]
Syntax Description
IP-ADDRESS
PEER-GROUP-NAME Name of a Border Gateway Protocol (BGP) peer group.
both
standard
extended
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65100
Switch(config-router)# address-family ipv4
Switch(config-router-af)# neighbor 10.4.4.4 send-community both
CLI Reference Guide
Use this command to specify that the communities attribute should be sent to a
BGP neighbor, use the no form of this command to remove the entry.
Specifies IP address prefixes.
(Optional) Specifies that both standard and extended communities will be sent.
(Optional) Specifies that only standard communities will be sent.
(Optional) Specifies that only extended communities will be sent.
None
Address family configuration
Router configuration
When a BGP peer group is specified using the PEER-GROUP-NAME argument,
then all the members of the peer group inherit the characteristics configured with
this command.
The following example, using the address family configuration mode, sets the
send-community with the both option (standard and extended):
Verify the settings by entering the show ip bgp neighbor command.
neighbor send-community
436