Pvid Vlan-Id - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

pvid VLAN-ID

pvid VLAN-ID
default pvid
Syntax Description
pvid VLAN-ID
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth4.1
Switch(config-if)# hybrid vlan 1000 untagged
Switch(config-if)# pvid 1000
CLI Reference Guide
Use the pvid interface configuration command to specify the native VLAN for the
trunk or hybrid interface. Use default interface command to reset to default
setting.
Specifies the PVID for the trunk or hybrid interface.
pvid VLAN-ID: 1 .(If the port is set to trunk/hybrid mode)
Interface configuration
The valid interfaces for this command are physical port or port-channel.
An interface can be specified with only one PVID. The succeeding command
overwrites the previous command.
This command is used to change PVID of Trunk or Hybrid port. When an
interface is Access mode, use the access VLAN command to change its PVID
instead of this command.
This command does not affect the VLAN membership and the port's tag handling
mode (Access, Hybrid or Trunk). Use the trunk allowed-VLAN or hybrid VLAN
command to add the port to the VLAN by the requirement. The specified VLAN
does not need to exist to make the command succeed.
This example shows how to set an interface port 4.1 as a hybrid interface with
native VLAN 1000.
Verify the settings by entering the show vlan command.
pvid VLAN-ID
486