Version - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

version

V
version { 1 | 2 }
Syntax Description
1
2
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)#router rip
Switch(config-router)#version 2
Switch(config-router)#exit
Switch(config)#
CLI Reference Guide
Use this command to specify the RIP version to send and receive.
Only RIP Version 1 packets are received and transmitted.
Only RIP Version 2 packets are received and transmitted.
Version 2
Router configuration
This command defines the default RIP version. This version will be overridden if
the version is explicitly specified for the interface (for example, interface
command "ip rip receive version" on page 306).
The following example shows how to configure the RIP version to version 2.:
Verify the settings by entering the show ip protocols rip command.
version
898