D-Link DGS-6600-48T Cli Reference Manual page 913

DGS-6604 m
Switch(config-if)#>vlan remarking 1002 200
Switch(config-if)#>cos remarking 7
Switch(config-if)#>cos remarking 3 101-102
Switch(config-if)#>no cos remarking
Switch(config-if)#>
CLI Reference Guide
3. Make a VLAN remarking from C-VID 200 to S-VID is 1002. So far the user's
COS is trusted.
4. Remark COS as 7.
5. Remark COS as 3 for C-VID 101-102, remarking COS as 7 for and 103-104
and 200.
6. Trust user's COS for VID 200 and 103-104(that is because when C-VID is not
specified with COS rearming policy explicitly, its COS is changed according
to cos remarking NEW-COS or no cos remarking commands), but remark
COS as 3 for C-VID 101-102.
7. Verify the settings by entering show vlan-tunnel interface command.
vlan remarking
903