Example usage:
To configure the PoE port:
DGS-1100-24P/ME:admin#config poe ports portlist 1-4 state enable
priority high
Command : config poe ports portlist 1-4 state enable priority high
Success.
DGS-1100-24P/ME:admin#
show poe system
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show PoE system information:
DGS-1100-24P/ME:admin#show poe system
Command: show poe system
PoE System Information
------------------------------------
Delivered (W)
Power Budget(W)
Trap State
DGS-1100-24P/ME:admin#
show poe ports
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
This command is used to display the settings and actual values of
the whole PoE system.
show poe system
This command is used to display the settings and actual values of
the whole PoE system.
None.
None.
: 6553.5(W)
: 100(W)
: Disabled
This command is used to display the settings and actual values of
the PoE port.
show poe ports { port_list <portlist>}
Displays the settings and actual values of the PoE port.
Note: For the PoE Status table, if the classification was shown
as "Legacy PD", it will be classified to non-AF PD or Legacy PD.
port_list <portlist> - Specifies a list of ports to be displayed.
None.
142