Synchronization - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

synchronization

synchronization
no synchronization
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65121
Switch(config-router)# synchronization
Switch(config-router)#
CLI Reference Guide
To enable the synchronization between Border Gateway Protocol (BGP) and an
external Interior Gateway Protocol (IGP) system, use the synchronization
command. To advertise a network route without waiting for the IGP, use the no
form of this command.
None
Disabled
Router configuration
Address family configuration
Usually, a BGP speaker does not advertise a route to an external neighbor
unless that route is local or exists in the IGP. By default, synchronization between
BGP and an IGP is disabled to allow the switch to advertise a network route
without waiting for route validation from the IGP. This feature allows routers and
access servers within an autonomous system to have the route before BGP
makes it available to other autonomous systems.
Use the synchronization command if the other routers in an autonomous
system do not speak BGP.
This example shows how to enable synchronization in AS 65121.
synchronization
871