DGS-6604
interface
interface INTERFACE-ID
Syntax Description
INTERFACE-ID
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth2.5
Switch(config-if)#
CLI Reference Guide
Enter the interface command to go into interface configuration mode. The
command executed in this mode will be applied to the interface specified by the
command.
The interface can be a physical port, port-channel, or VLAN.
None
Global configuration
The interface command puts the command line interface into interface
configuration mode for a specified interface.
For the port-channel interface, it must be an existing channel-group.
For the VLAN interface, it must be a previously created VLAN.
This example shows how to enter the interface configuration mode for eth2.5:
interface
211