Route Map Match Ip Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m
match ip address
match ip address ACCESS-LIST-NAME
no match ip address [ACCESS-LIST-NAME]
Syntax Description
ACCESS-LIST-NAME
Default
Command Mode
Usage Guideline
Example
Switch(config)# ip access-list myacl
Switch(config-ip-acl) # permit 10.20.0.0 255.255.0.0 any
Switch(config-ip-acl)# exit
Switch(config)# route-map myPolicy permit 1
Switch(config-route-map)# match ip address myacl
CLI Reference Guide
Use this command to define a clause to match the route based on IP standard
access list.
Specify a standard or an extended IP access list name.
Not configured
Route-map configuration
Use the match ip address command in route map configure mode to define rule
for matching routes against IP standard access list.
The following example create an IP access list "myacl" first and create a route
map entry to match against the create IP access list.
You can verify your settings by entering the show route map command.
match ip address
411