Passive-Interface (Rip Ipv) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m
passive-interface (RIP IPv6)
passive-interface IFNAME
no passive-interface IFNAME
Syntax Description
IFNAME
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)#router ipv6 rip
Switch(config-router)# passive-interface vlan1
Switch(config-router)#exit
CLI Reference Guide
To disable sending routing updates on an interface, use the passive-interface
command . To re-enable sending routing updates, use the no form of this
command.
Specifies the Interface type and Interface number.
Routing updates are sent on the interface.
Router configuration
If the sending of routing updates is disabled on an interface, the particular subnet
will continue to be advertised to other interfaces. In addition, updates from other
routers on that interface will continue to be received and processed.
The following example shows how to disable sending routing updates on the
interface VLAN 1:
Verify the settings by entering the show ipv6 rip interface command.
passive-interface (RIP IPv6)
451