Set Community - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

set community

set community { COMMUNITY-NUMBER [additive] | WELL-KNOWN-COMMUNITY [additive] |
none }
no set community {COMMUNITY-NUMBER [additive] | WELL-KNOWN-COMMUNITY [additive]
}
Syntax Description
COMMUNITY-
NUMBER
WELL-KNOWN-
COMMUNITY
additive
none
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use this command to set the BGP communities attribute, to delete an entry, use
the no form of this command.
The community number value. It is presented in a "AA:NN" format, and the AA
and the NN both are numbers from 0 to 65535.
(Optional) Well known communities can be specified by using the following
keywords:
internet : Specifies routes not to be advertised to the Internet.
local-AS: Specifies routes not to be advertised peers outside of the AS including
sub-AS.
no-advertise: Specifies routes not to be advertised to other BGP peers.
no-export: Specifies routes not to be advertised outside of Autonomous System
boundary.
(Optional) Adds the community to the already existing communities.
Removes the community attribute from the prefixes that pass the route map.
Disabled
Route-map configuration
BGP community exchange is not enabled by default. It is enabled on a per-
neighbor basis with the neighbor send-community command.
The community will be sent out in the BGP packet only when set community is
specified in the route map, and if all match criteria are met, all set actions are
performed.
If additive is not specified, the user-defined communities in the route will be
replaced.
User-defined community is transitive, Well-known community is not-transitive.
This command is useful for routes received from EBGP and to be transmitted to
IBGP.
set community
535