Show Ip Source Binding - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip source binding

show ip source binding [IP-ADDRESS] [MAC-ADDRESS] [dhcp-snooping | static] [vlan VLAN-
ID] [interface INTERFACE-ID [, | -] ]
Syntax
IP-ADDRESS
MAC-ADDRESS
dhcp-snooping
static
vlan VLAN-ID
INTERFACE-ID
,
-
Default
Command Mode
Usage Guideline
Example
Switch# show ip source binding
MAC Address
----------------- --------------- ---------- ------------- ----- ----------
------
00-01-01-01-01-01 10.1.1.10
00-01-01-01-01-10 10.1.1.11
Total Entries: 2
Switch#
CLI Reference Guide
Use the command to display IP-source guard binding entry.
(Optional) Display the IP-source guard binding entry based on IP address.
(Optional) Display the IP-source guard binding entry based on MAC address.
(Optional) Display IP-source guard binding entry learned by DHCP binding
snooping.
(Optional) Display IP-source guard binding entry that is manually configured.
(Optional) Display the IP-source guard binding entry based on VLAN.
(Optional)Display the IP-source guard binding entry based on ports.
(Optional) Specify a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specify a range of interfaces. No space before and after the hyphen.
Not applicable
EXEC mode or any configuration mode
IP source guard use binding entries that are either manually configured or auto
learned by DHCP snooping.
The command accepts combination of input options to filter the displayed entry.
This example shows how to display IP Source Guard binding entries without any
parameter.
IP Address Lease(sec) Type
infinite static
3120 dhcp-snooping 100
show ip source binding
VLAN Interface
100 eth3.3
eth3.3
789