Switchport Voice-Vlan State - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

switchport voice-vlan state

switchport voice-vlan state {enable | disable}
Syntax Description
enable
disable
Default
Command Mode
Usage Guideline
Example
Switch(config)#interface eth3.1
Switch(config-if)#switchport voice-vlan state enable
Switch(config-if)#end
Switch#
CLI Reference Guide
Use the command to configure the voice VLAN state of ports.
Enable the voice VLAN function on ports.
Disable the voice VLAN function on ports.
The default state is disabled.
Interface configuration mode.
This command is used to enable/disable the voice VLAN function on ports.
The command is available for physical port and port-channel interface
configuration.
This example shows how to enable voice VLAN function on physical port eth3.1.
You can verify your settings by entering show vlan voice-vlan interface
command.
switchport voice-vlan state
821