Erpi Rpl - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

erpi rpl

erpi INSTANCE-ID rpl owner rpl-port {east | west }
no erpi INSTANCE-ID rpl
Syntax Description
INSTANCE-ID
owner
rpl-port
Default
Command Mode
Usage Guideline
Example
Switch(config-erps-domain)# erpi 1 rpl owner rpl-port east
Switch(config-erps-domain)#
Switch(config-erps-domain)# erpi 2 rpl owner rpl-port west
Switch(config-erps-domain)#
Switch(config-erps-domain)# no erpi 1 rpl
Switch(config-erps-domain)#
CLI Reference Guide
Use the erpi rpl command to configure an ERP instance as the RPL owner and
the RPL port. Use the no form of this command to remove the RPL related
setting.
Specifies the identifier of ERP instance. The valid range is 1 to 4095.
Specifies the ring node as the RPL owner of the ERP instance.
Specifies one of the ring ports as the RPL port.
Not configured
ERPS domain configuration mode
Use the command to specify one of the nodes in the ring as the RPL owner, and
one of its ring ports as the RPL port.
The setup of the RPL owner and RPL port are required for operation of the ring.
The following example shows how to enable RPL owner and configure RPL port
to east ring port of ERP instance 1:
The following example shows how to enable RPL owner and configure RPL port
to west ring port (non-shared) of ERP instance 2:
The following example shows how to disable RPL owner of ERP instance 1:
erpi rpl
190