Vlan-Tunnel Ctag-Mapping Dynamic - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vlan-tunnel ctag-mapping dynamic

vlan-tunnel ctag-mapping dynamic { ipv4 | ipv6 } { enable | disable}
Syntax Description
ipv4
ipv6
enable
disable
Default
Command Mode
Usage Guideline
Examples
Switch(config)# vlan-tunnel ctag-mapping dynamic ipv4 enable
CLI Reference Guide
Use this command to enable or disable the dynamic customer VLAN tag learning
mechanism for IPv4/IPv6 packets.
Specifies IPv4 packets.
Specifies IPv6 packets.
Enables the VLAN tunnel dynamic customer VLAN tag learning mechanism.
Disables the VLAN tunnel dynamic customer VLAN tag learning mechanism.
Disabled
Global configuration
Use this command to enable the dynamic customer VLAN tag learning
mechanism. The mechanism learns the customer VLAN tag and source IP
address mapping from incoming control packets. The learned customer VLAN
tag mapping will be used for outgoing Layer 3 control packets. When a Layer 3
control packet is sent, and its destination IP is the same value as the source IP of
dynamic learned customer VLAN tag mapping entry, then the control packet will
be added to the matched customer VLAN tag.
If VLAN tunneling mode is disabled, the mechanism will not work even it is
enabled.
This example shows how to enable the VLAN tunnel dynamic customer VLAN
tag learning mechanism for IPv4 packets.
Verify the settings by entering show vlan-tunnel ctag-mapping dynamic state
command.
vlan-tunnel ctag-mapping dynamic
905