Show Dot1X - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show dot1x

show dot1x [interface INTERFACE-ID ] {auth-state | auth-configuration | statistics |
diagnostics | session-statistics}
Syntax Description
interface
INTERFACE-ID
auth-state
auth-configuration
statistics
diagnostics
session-statistics
Default
Command Mode
Usage Guideline
Examples
Switch#show dot1x interface eth4.1 auth-configuration
System Auth Control: Enabled
Authentication Protocol: Local
eth4.1
PAE: Authenticator
Control Direction: Both
Port Control: Auto
Quiet Period: 60
Tx Period: 30
Supp Timeout: 30
Server Timeout: 30
Max-req: 2
Reauth Period: 3600
Re-authentication: Disabled
Authentication Mode: Host-based
Guest VLAN: Disabled
Forward 1x PDU: Disabled
Total Entries: 1
CLI Reference Guide
Use this command to display information about the: 802.1X state, configuration,
statistics, diagnostics, session statistics, or authentication client.
(Optional) Specifies a port to display the authentication state, configuration,
statistics, diagnostics, or session statistics. This option is only valid for a physical
port interface.
Display information of 802.1X state.
Display information of 802.1X configuration.
Display information of 802.1X statistics.
Display information of 802.1X diagnostics.
Display information of 802.1X session statistics.
None
User EXEC or any configuration mode
If a port is not specified, then information for all ports will be displayed.
This example shows how to display the authentication configuration for port
eth4.1.
show dot1x
577