Ip Arp Inspection Trust - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip arp inspection trust

ip arp inspection trust
no ip arp inspection trust
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface eth3.3
Switch(config-if)# ip arp inspection trust
Switch(config-if)#
CLI Reference Guide
Use the command to trust an interface for dynamic ARP inspection. Use the no
form of the command to disable the trust state.
Not applicable.
un-trusted
Interface configuration mode
The command is available for physical port configuration.
When an interface is in ip arp inspection trust state, the ARP packets arriving at
the interface will not be inspected. When an interface is in ip arp inspection
untrust state, the ARP packets arriving at the port and belong to the VLAN that is
enabled for inspection will be inspected.
This example shows how to configure port 3.3 to be trusted for DAI:
ip arp inspection trust
227