Vrrp Timers Advertise - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vrrp timers advertise

vrrp VRID timers advertise INTERVAL
no vrrp VRID timers advertise
Syntax Description
VRID
INTERVAL
Default
Command Mode
Usage Guideline
Examples
Switch(config)#interface vlan1
Switch(config-if)#vrrp 7 timers advertise 10
Switch(config)#interface vlan1
Switch(config-if)#no vrrp 7 timers advertise
CLI Reference Guide
This command configures the interval between successive advertisements by
the master router. To restore the default value, use the no form of this command.
Specifies the virtual router identifier, which is the number identifying the virtual
router that the advertisement timing is being configured for.
The virtual router identifier is configured with the command "vrrp ip" on
page 917.
Range is from 1 to 255.
Time interval between successive advertisements by the master router. The unit
of the interval is in seconds.
Range is from 1 to 255 seconds.
Interval: 1 second
Interface configuration
The VRRP advertisements being sent by the master virtual router communicate
the state and priority of the current master virtual router.
The vrrp timers advertise command configures the time between the
advertisement packets and the time before other routers declare the master
router to be down. All routers in a VRRP group must use the same timer values.
The following example shows how to configure the router to send advertisements
every 10 seconds.
The following example shows how to configure the advertisement interval to
default.
vrrp timers advertise
923