Shutdown (Interface) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

shutdown (interface)

shutdown
no shutdown
Syntax
Default
Command Mode
Usage Guideline
Examples
Switch(config)# interface eth3.1
Switch(config-if)# shutdown
CLI Reference Guide
Use this command to disable the port interface. Use the no form of the command
to enable the port interface.
None
Enabled
Interface configuration
Only physical port interfaces are valid for this configuration.
The command will change the state of a port to be disabled. In the disabled state,
the port will not be able to receive or transmit any packets. Using the no
shutdown command, the port will set the port to the enabled state. When a port is
shutdown (disabled), the link status will also be off.
Below demonstrates using the shutdown command to set interface port eth3.1
to the disabled state
shutdown (interface)
770