Show Policy-Map - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show policy-map

show policy-map [POLICY-NAME | interface INTERFACE-ID]
Syntax Description
INTERFACE-ID
POLICY-NAME
Default
Command Mode
Usage Guideline
Examples
Switch(config)#class-map police
Switch(config-cmap)#match access-list acl_rd
Switch(config-cmap)#policy-map policy1
Switch(config-pmap)#class police
Switch(config-pmap-c)#police cir 500000 bc 10000 pir 1000000 be 10000
exceed-action set-dscp-transmit 2 violate-action drop
Switch(config-pmap-c)#exit
Switch(config-pmap)#exit
Switch(config)#interface eth3.1
Router(config-if)#service-policy policy1
Router(config-if)#end
CLI Reference Guide
Use this command to display the policy map configuration.
(Optional) Module and port number.
(Optional) Specifies the name of the policy map. If not specified, all policy maps
will be displayed.
None
User EXEC or any configuration mode
The show policy-map command displays the class policies configured for the
policy map. Use the show policy-map command to display all class policy
configurations comprising any existing service policy map.
The command show policy-map INTERFACE-ID displays the policy map
configuration if the service policy has been attached to the specified interface.
The following is sample output from the show policy-map command. As shown
below, in the policy map called policy1, two-rate traffic policing has been
configured for the class called police. Two-rate traffic policing has been
configured to limit traffic to an average committed rate of 500 Mbps and a peak
rate of 1 Gbps.
show policy-map
718