D-Link DGS-6600-48T Cli Reference Manual page 332

DGS-6604
Examples
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan2
Switch (config-if) # ipv6 address my-prefix 0:0:0:1::1/64
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan2
Switch (config-if) # no ipv6 address my-prefix 0:0:0:1::1/64
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan2
Switch (config-if) # ipv6 address 3ffe:22:22:22::2/64
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan2
Switch (config-if) # no ipv6 address 3ffe:22:22:22::2/64
CLI Reference Guide
The following example shows how to enable IPv6 processing on the interface
and configure an address based on the general prefix called my-prefix and the
directly specified bits:
Assuming the general prefix named my-prefix has the value of 3ffe:1:2::/48, then
the interface would be configured with the global address: 3ffe:1:2:1::1/64. If no
general prefix named my-prefix is set, then no IPv6 address will be set.
If the general prefix named my-prefix is an acquired through a DHCPv6 Client
prefix delegation, then the global address would be configured after the prefix is
received from the DHCPv6 Client.
The following example shows how to remove a general prefix named my-prefix
on the interface:
The following example shows how to manually configure a global address:
After the command is entered, the global address 3ffe:22:22:22::2/64 will be
immediately set.
The following example shows how to manually remove a global address from the
configuration:
After the command is entered, the global address 3ffe:22:22:22::2/64 will be
immediately removed.
ipv6 address
322