Router-Id - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

router-id

router-id IP-ADDRESS
no router-id
Syntax Description
IP-ADDRESS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# router-id 10.10.10.60
CLI Reference Guide
Use this command to specify a router ID for the OSPF process. Use the no form
of the command to revert to the automatic determination of router-id.
Specifies the router ID in IPv4 address format.
The router-id is automatically chosen based on the highest IP address present
on the router.
Router configuration
Router ID is a 32-bit number assigned to each router running the OSPF protocol.
This number uniquely identifies the router within an Autonomous System. Each
router must be configured with a unique router-id.
If this command is used on an active OSPF router process (already has
neighbors), the new router-ID will not take effect immediately. It will be used at
the next reload or at a manual OSPF process restart.
This example shows how to configure router id to 10.10.10.60
Verify the settings by entering the show ip protocols ospf command.
router-id
518