Interface Tunnel - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

interface tunnel

interface tunnel {tunnel-ID}
no interface tunnel {tunnel-ID}
Syntax Description
tunnel-ID
Default
Command Mode
Usage Guideline
Examples
Switch(config)# interface tunnel 2
Switch (config-if)#
Switch(config)# no interface tunnel 2
Switch (config)#
CLI Reference Guide
Use the interface tunnel configuration command to add a tunnel and to enter the
interface configuration mode. Use the no interface tunnel configuration
command to remove a tunnel.
Specifies the ID of the tunnel to be added, removed or configured. The valid
tunnel ID range is 1-127.
None
Global configuration
None
The following example will add a tunnel of 2, and then enter into the interface
configuration mode.
The following example will remove IPv6 tunnel 2.
interface tunnel
213