Accept Dhcp Relay-Agent - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

accept dhcp relay-agent

accept dhcp relay-agent [circuit-id|remote-id]
no accept dhcp relay-agent [circuit-id|remote-id]
Syntax Description
circiut-id
remote-id
Default
Command Mode
Usage Guideline
Examples
switch > enable
switch# configure terminal
switch(config)# ip dhcp pool pool1
switch(config-dhcp)# accept dhcp relay-agent
switch(config-dhcp)#
switch > enable
switch# configure terminal
switch(config)# ip dhcp pool pool1
switch(config-dhcp)# no accept dhcp relay-agent remote-id
switch(config-dhcp)#
CLI Reference Guide
To accept relay agent information use the accept dhcp relay-agent command,
use the no form of the command to reject DHCP relay agent information.
(Optional) Agent Circuit ID Sub-option.
(Optional) Agent Remote ID Sub-option
DHCP relay-agent is not accepted.
DHCP pool configuration
If either of circuit-id and remote-id is not specified, it implys that both the circuit-id
and remote-id options are applied with the command. If only the circuit-id or
remote-id is specified, it implies that it only accepts DHCP packets containing
either only a circuit-id or a remote-id.
The following example sets DHCP pool1 to accept circuit id and remote id relay
agent information.
The following example sets DHCP pool1 to not accept remote id relay agent
information.
accept dhcp relay-agent
32