Show Poe System - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
If no parameter is specified, the system will display the status for all the ports.
Restrictions
None.
Example
To display PoE port configurations on port 1 to 6:
DGS-3620-28PC:admin# show poe ports 1:1-1:6
Command: show poe ports 1:1-1:6
Port State Priority
Class Power(mW) Voltage(decivolt)
Status
===============================================================================
1:1 Enabled Critical
0 0
OFF : Interim state during line detection
1:2 Enabled Critical
0 0
OFF : Interim state during line detection
1:3 Enabled Critical
0 0
OFF : Interim state during line detection
1:4 Enabled Critical
0 0
OFF : Interim state during line detection
1:5 Enabled Low
0 0
OFF : Interim state during line detection
1:6 Enabled Low
0 0
OFF : Interim state during line detection
DGS-3620-28PC:admin#
77-4

show poe system

Description
This command is used to display the settings and actual values of the whole PoE system.
Note: This command is only available to Switches in the DGS-3620 Series that support Power
over Ethernet.
Format
show poe system {units <unitlist>}
Power Limit(mW)
4000 (Class 1)
0
4000 (Class 1)
0
4000 (Class 1)
0
4000 (Class 1)
0
7000 (User-defined)
0
7000 (User-defined)
0
857
Time Range
Current(mA)
0
0
0
0
0
0