Neighbor Update-Source - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

neighbor update-source

neighbor { IP-ADDRESS | PEER-GROUP-NAME } update-source INTERFACE-ID
no neighbor { IP-ADDRESS | PEER-GROUP-NAME } update-source INTERFACE-ID
Syntax Description
IP-ADDRESS
PEER-GROUP-NAME Name of a Border Gateway Protocol (BGP) peer group
INTERFACE-ID
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65100
Switch(config-router)# neighbor 172.16.10.10 update-source vlan1
CLI Reference Guide
Use this command to allow internal BGP sessions to use any operational
interface for TCP connections. Use the no form of this command to restore the
interface assignment to the closest interface.
Specifies IP address prefixes
Specifies the interface ID
The best local address is used.
Router configuration
Use this command in conjunction with any specified interface on the router.
The following example shows how to configure the internal BGP sessions to use
VLAN 1 for the neighbor 172.16.10.10:
Verify the settings by entering the show ip bgp neighbor command.
neighbor update-source
439