Dot1X Port-Control - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

dot1x port-control

dot1x port-control { auto | force-authorized | force-unauthorized }
Syntax Description
auto
force-authorized
force-unauthorized
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x port-control force-unauthorized
CLI Reference Guide
Use this command to manually control the authorization state on a specific port.
The state (authorized or unauthorized) for a specific port is determined
according to the outcome of the authentication.
Specifies to force the port to change to the authorized state. The port allows
access and all authentication packets are ignored.
Specifies to force the port to change to the unauthorized state. The port is
blocked and all authentication packets are ignored.
auto
Interface configuration
This command is valid only for physical port interface.
Global 802.1x authentication function should be enabled using the dot1x
system-auth-control command on page 173 before enabling 802.1X
authentication on a specific port.
This example shows how to deny all access on eth4.1.
Verify the settings with the show dot1x auth-configuration command.
dot1x port-control
170