Redistribute (Rip Ipv) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m
redistribute (RIP IPv6)
redistribute PROTOCOL [metric METRIC-VALUE]
no redistribute PROTOCOL
Syntax Description
PROTOCOL
METRIC-VALUE
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use redistribute to redistribute routes from one routing domain into another
routing domain. Use no command to disable redistribution.
Source protocol from which routes are being redistributed. It can be one of the
following keywords: connected, ospf, and static.
(Optional) Specifies metric value to be used in redistributing information. The
range is 0 to 16.
Disabled
PROTOCOL: Not configured
METRIC-VALUE: 1.
Router configuration
Routes configured with the connected keyword affected by this redistribute
command are the routes not specified by the network router configuration
command.
Regarding the metric conversion, the following is the rule.
If the metric option is not specified, the following rules are applied:
1. If the metric is not specified, or is specified as 0, the metric for the redistrib-
uted static route or connected route will be 1.
2. If the metric is not specified, the metric for the redistributed route from other
protocols to RIP process will be determined by the value of the "default-met-
ric" command.
3. If the metric is specified as 0, the metric for the redistributed route from other
protocols to RIP process will be 1.
Also, if the default-metric is not specified, then the original metric from the
redistributed protocol will be transparently carried through.
1. The default-metric command cannot be used to affect the metric used to
advertise connected routes.
2. The metric value specified in the redistribute command supersedes the met-
ric value specified using the default-metric command.
redistribute (RIP IPv6)
509