Police Aggregate - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

police aggregate

police aggregate NAME
no police aggregate NAME
Syntax Description
NAME
Default
Command Mode
Usage Guideline
Example
Switch(config)# qos aggregate-policer agg_policer1 64 128 exceed-action drop
Switch(config)# policy-map policy2
Switch(config-pmap)# class class1
Switch(config-pmap-c)# police aggregate agg_policer1
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class2
Switch(config-pmap-c)# police aggregate agg_policer1
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class3
Switch(config-pmap-c)# police aggregate agg_policer1
Switch(config-pmap-c)# exit
CLI Reference Guide
To configure a named aggregate policer as the policy for a traffic class in a policy
map, use police aggregate command in the policy map class configuration mode.
To delete the name aggregate policer from class policy, use the no form of this
command.
Specifies a previously defined aggregate policer name as the aggregate policer
for a traffic class. Up to 32 characters are allowed.
None
Policy map class configuration
Use the qos aggregate-policer command in global configuration mode to create a
named aggregate policer, and then use the police aggregate command in the
policy-map class configuration mode to configure the named aggregate policer
as the policy for a traffic class. A named aggregate policer cannot be referred
from different policy map.
This example shows how to configure a named aggregate policer parameters
and apply the policer to multiple classes in a policy map: An aggregate policer
with single rate policing named agg_policer1 is created. This policer is configured
as the policy for traffic class class1, class2, and class3.
Verify the settings by entering the show policy-map command.
police aggregate
477