Ip Ospf Shutdown - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip ospf shutdown

ip ospf shutdown [ IFNAME ]
no ip ospf shutdown [ IFNAME ]
Syntax Description
IFNAME
Default
Command Mode
Usage Guideline
Example
Switch(config)# router ospf
Switch(config-router)# ip ospf shutdown vlan1
CLI Reference Guide
To initiate a graceful shutdown of Open Shortest Path First (OSPF) protocol at
interface level, use the ip ospf shutdown command in router configuration
mode. To restart the OSPF protocol on an interface, use the no form of this
command.
(Optional) Specifies a layer 3 interface. If no option is specified, the command
applies to the entire OSPF process.
None
Router configuration
Use the ip ospf shutdown command to place the OSPF protocol, on a specific
interface, into shutdown mode.
If no interface is specified with this command, the entire protocol will shutdown in
the least disruptive manner and notify its neighbors that it is not available.
Traffic that can follow another route through the network, will be directed to that
alternate path.
The following example shows how to initiate an OSPF protocol shutdown on the
layer 3 interface (VLAN 1):
ip ospf shutdown
284