Ip Address-List - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip address-list

ip address-list IP-ADDRESS [,|-]
no ip address-list IP-ADDRESS [,|-]
Syntax Description
IP-ADDRESS [,|-]
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp)# ip address-list 10.1.1.1-10.1.1.255
Switch(config-dhcp)# no ip address-list 10.1.1.200
Switch(config-dhcp)#
CLI Reference Guide
Use this command to specify the IP addresse range in a DHCP address pool and
one of which is allowed to be bound with a DHCP client. Use the no form of this
command to remove the range of IP addresses from the DHCP address pool.
The IP address list to be added into DHCP address pool.
No IP addresses exist in any DHCP pool.
DHCP pool configuration
This command is used to define the IP address list for a DHCP pool. Reasonable
IP addresses should be carefully defined for the pool. For example, use the same
network ID or same subnet for the all IP addresses.
Specify a host by specifying the IP address explicitly or specify a range of IP
addresses using a hyphen between the start IP address and end IP address.
Both the host and the range of IP addresses can be mixed together. Verify and
confirm that the IP addresses chosen are part of the same network.
This example shows how to configure the IP address range for pool1 in the IP
address range of 10.1.1.1~10.1.1.255 and exclude the address 10.1.1.200 from
the pool.
Verify the address pool is added with the show ip dhcp pool command.
ip address-list
219