Show Poe System - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
show poe ports {<portlist>}
Parameters
ports - (Optional) Specifies the list of ports to be displayed here.
<portlist> - Enter the list of ports, used for the display, here.
If no parameter is specified, the system will display the status for all the ports.
Restrictions
None.
Example
To display PoE port configurations on port 1 to 6:
DGS-3620-28PC:admin# show poe ports 1:1-1:6
Command: show poe ports 1:1-1:6
Port State
Class
Status
===============================================================================
1:1 Enabled
0
OFF : Interim state during line detection
1:2 Enabled
0
OFF : Interim state during line detection
1:3 Enabled
0
OFF : Interim state during line detection
1:4 Enabled
0
OFF : Interim state during line detection
1:5 Enabled
0
OFF : Interim state during line detection
1:6 Enabled
0
OFF : Interim state during line detection
DGS-3620-28PC:admin#
84-4

show poe system

Description
This command is used to display the settings and actual values of the whole PoE system.
Note: This command is only available to Switches in the DGS-3620 Series that support Power
over Ethernet.
Priority Power Limit(mW)
Power(mW) Voltage(decivolt)
Critical 4000 (Class 1)
0 0
Critical 4000 (Class 1)
0 0
Critical 4000 (Class 1)
0 0
Critical 4000 (Class 1)
0 0
Low 7000 (User-defined)
0 0
Low 7000 (User-defined)
0 0
Time Range
Current(mA)
0
0
0
0
0
0
980