Ip Trusted-Host - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip trusted-host

ip trusted-host {IP-ADDRESS | NETWORK-ADDRESS/PREFIX-LENGTH} [snmp] [http] [telnet]]
no ip trusted-host [IP-ADDRESS | NETWORK-ADDRESS/PREFIX-LENGTH] [snmp] [http]
[telnet]
Syntax Description
IP-ADDRESS
NETWORK-
ADDRESS/PREFIX-
LENGTH
snmp
http
telnet
Default
Command Mode
Usage Guideline
Examples
Switch(config)# ip trusted-host 163.10.50.126 snmp
CLI Reference Guide
Use this command to create the trusted host entries on the switch. Use the no ip
trusted-host command to remove the trusted host entries.
IPv4 address of the trusted host.
IPv4 network of the trusted host.
(Optional) Specifies that the host is valid for snmp.
(Optional) Specifies that the host is valid for http.
(Optional) Specifies that the host is valid for telnet.
No default hosts
Global configuration at privilege level 15.
The ip-trusted host command creates the trusted host entries with access to the
management interface. When a trusted-host is not configured, then all hosts are
trusted. When adding a trusted-host, if the access interface (snmp, http, or telnet)
is not specified, then it applies to all interfaces.
Once a trusted-host is configured with an access interface allowed, then only the
configured trusted-hosts are allowed access to the access interfaces associated
with their entry. If an access interface is not specified in the trusted-host list, then
all access to that access interface will be blocked.
The number of trusted hosts is project dependent.
For the no command, when the host is not specified, all hosts will be deleted for
the specified access interface. If no access interface is specified, the specified
host will be deleted for all access interfaces. If both the host and access interface
are not specified, all trusted hosts will be deleted.
This example shows how to add a trusted host with IP address 163.10.50.126 to
snmp access interface.
ip trusted-host
315