Vlan-Tunnel Interface-Type - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vlan-tunnel interface-type

vlan- tunnel interface-type { nni | uni }
Syntax Description
nni | uni
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)#interface eth3.1
Switch(config-if)#vlan-tunnel interface-type nni
CLI Reference Guide
Use this command to configure an interface as NNI (Network-to Network) or UNI
(User-to-Network).
Specifies the interface type for the interface (port channel or ethernet port).
nni - Network to Network Interface.
uni - User to Network Interface.
When a VLAN tunnel is enabled, all interface are set as a nni port.
Interface configuration
This command sets the interface type at the port used by the VLAN tunnel
application.
uni - User to Network Interface.
nni - Networks to Network Interface.
This example shows how to set Ethernet eth3.1 NNI port.
Verify the settings by entering show vlan-tunnel command.
vlan-tunnel interface-type
908