Show Cpu-Protect Sub-Interface - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show cpu-protect sub-interface

show cpu-protect sub-interface { manage | protocol | route } [UNIT-ID]
Syntax Description
UNIT-ID
Default
Command Mode
Usage Guideline
Example
Switch# show cpu-protect sub-interface manage
Sub-Interface: manage
Pps : 300
Slot
--------------
1(CM-card)
3
Switch#
Switch# show cpu-protect sub-interface protocol
Sub-Interface: protocol
Pps : N/A
Slot
--------------
1(CM-card)
3
Switch#
CLI Reference Guide
Use this command to show the rate-limit and statistics by sub-interface.
(Optional) Specify the unit id, that you want, to display the rate limit configuration
and statistics by sub-interface. For the chassis system device, the unit ID is
equal to a blade ID (or slot ID).
none
Privileged EXEC mode
Show configured rate limit and drop-count of Safeguard engine of specific group.
These counters are counted by the software. There is probably deviation from
the hardware received if the packets are dropped before sent to CPU.
The following example is a sample output of the show cpu-protect sub-interface manage
command. The configured rate is 300 packets per second, and there exists one IO-card on
slot 3.
Total Drop
--------- ---------
50 0
50 0
The following is a sample output of the show cpu-protect sub-interface
protocol command. The Pps is "N/A" which means no rate-limit is applied to
route sub-interface.
Total Drop
--------- ---------
0
0
0
0
show cpu-protect sub-interface
574