Lacp System-Priority - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

lacp system-priority

lacp system-priority PRIORITY
no lacp system-priority
Syntax Description
PRIORITY
Default
Command Mode
Usage Guideline
Example
Switch(config)# lacp system-priority 30000
CLI Reference Guide
Use the lacp system-priority command to configure the system priority used for
LACP ports. Use the no form to configure the system priority to the default.
Specifies the system priority. The range is 1 to 65535.
32768.
Global configuration
During Link Aggregation Control Protocol (LACP) negotiation, the system priority
and port priority of the local partner are exchanged with the remote partner. If the
maximum number of actual members exceeds the limitation, the switch uses port
priority to determine whether the port status will be in backup mode or active
mode. The LACP system priority determines which switch controls the port
priority for the aggreagated link. The port priorities of the other switch are
ignored.
In a system priority comparison, a numerically lower value has a higher priority.
If two switches have the same system priority , the LACP system ID (MAC
address) determines the priority.
The LACP system priority command applies to all LACP port channels on the
switch.
This example shows how to configuration the system priority to 30000.
Verify the settings with the show channel-group command
lacp system-priority
366