Ip Policy Route-Map - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip policy route-map

Syntax Description
MAP-NAME
Default
Command Mode
Usage Guideline
Examples
CLI Reference Guide
Use the command to specify a route map as the routing policy on an interface,.
To disable policy routing on the interface, use the no form of this command.
ip policy route-map MAP-NAME
no ip policy route-map [MAP-NAME]
Specify the name of the route map to be used for routing policy.
Policy routing is disabled.
Interface configuration mode.
The command is only available for VLAN interface configuration.
The user can specify one route map as the routing policy on an interface. The
policy will be applied to packets received by the interface.
Use the match ip-address command in route map to define the matching criteria
for packets with specific characteristics. If IP access list is used with the match
ip-address command, all of the matching criteria in the access list will be
checked. The packet that matches that permit statement will be acted based on
the route map. The packet that is denied by the access list will be routed based
on routing table.
Use the following set command to define the action to take for policy based
routing:
set ip precedence
set interface
set ip next-hop
set ipv6 next-hop
set default interface
set ip default next-hop
set ipv6 default next-hop
The following example set up routing policy to route the packets that match the IP
access list name pbr-acl to next-hop 20.1.1.254
ip policy route-map
301