Mac Address-Table Aging Destination-Hit - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

mac address-table aging destination-hit

mac address-table aging destination-hit
no mac address-table aging destination-hit
Syntax
Default
Command Mode
Usage Guideline
Example
Switch:15(config)# mac address-table aging destination-hit
CLI Reference Guide
Use the MAC address-table aging destination-hit command to enable the
destination MAC address triggered update function (Updates the hit bit of the
MAC address entry based on the destination MAC of the forwarding packet).
Use the no form of the command to disable the triggered updated function.
None
Disabled
Global configuration
The source MAC address triggered update function is always enabled. When a
user enables the destination MAC address triggered update function by entering
the "mac address-table aging destination-hit" command, the hit bit of MAC
address entries will be updated. It will be updated for either the destination MAC
addresses or the source MAC addresses when the forwarding packet is
matched. The destination MAC address triggered update function increases the
frequency of the MAC address entries hit bit update and will reduce the traffic
flooding when the aging of MAC address entries expires.
This example shows how to enable the destination MAC address triggered
update function.
Verify the setting by entering the show mac address-table aging destination-
hit command.
mac address-table aging destination-hit
401