D-Link Discovery Protocol (Ddp) Clientcommands - D-Link Dis-200G Series Cli Reference Manual

9. D-Link Discovery Protocol (DDP)
ClientCommands
9-1 ddp
This command is used to enable DDP client function globally. Use the no form of this command to disable DDP
client.
ddp
no ddp
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enable or disable DDP client function globally.
Example
This example shows how to enable DDP globally.
Switch# configure terminal
Switch(config)# ddp
Switch(config)#
This example shows how to disable DDP.
Switch# configure terminal
Switch(config)# no ddp
Switch#
9-2 ddp report-timer
This command is used to configure interval between two consecutive DDP report messages. Use the
no form of this command to revert to the default setting.
ddp report-timer {30| 60| 90|120 |Never}
no ddp report-timer
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
40