Activating An Rrpp Domain; Configuring Rrpp Timers - 3Com 4500G Family Configuration Manual

Activating an RRPP Domain

To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the
RRPP domain on the current device.
Perform this operation on all nodes in the RRPP domain.
Follow these steps to activate an RRPP domain:
To do...
Enter system view
Enable RRPP
Enter RRPP domain view
Enable the specified RRPP ring
To prevent Hello packets of subrings from being looped on the primary ring, enable the primary ring on
its master node before enabling the subrings on their separate master nodes. On an edge node or
assistant-edge node, enable/disable the primary ring and subrings separately as follows:
Enable the primary ring of an RRPP domain before enabling the subrings of the RRPP domain.
Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.

Configuring RRPP Timers

Perform this configuration on the master node of an RRPP domain.
Follow these steps to configure RRPP timers:
To do...
Enter system view
Enter RRPP domain view
Configure the Hello timer and
Fail timer for the RRPP domain
Use the command...
system-view
rrpp enable
rrpp domain domain-id
ring ring-id enable
Use the command...
system-view
rrpp domain domain-id
timer hello-timer hello-value
fail-timer fail-value
1-15
Remarks
—
Required
Disabled by default
—
Required
Disabled by default
Remarks
—
—
Required
By default, the Hello timer value
is 1 second and the Fail timer
value is 3 seconds.